McHale
995 L+T
Square Bale Wrapper
60
11.5 Table half tip magnet (995 LSR & TSR)
The table half tip magnet does not normally require adjustment. However, as it is used
as for the half tip position on electronic machines, it may need to be re-set. This will
also affect the cut & hold operation.
1.
Tip up the table and fit the safety bar
2.
Loosen the M6 nut on the magnet
3.
Move the magnet upwards to sense when the table is nearer the chassis, i.e.
Table lowers more before indexing
4.
Move the magnet downwards to sense when the table is further away from the
chassis, i.e. Table lowers less before indexing
.
Do not push down too far, as
the table may hit the bale damper while indexing.
5.
Tighten the M6 nut
6.
Remove the table safety bar and lower the table back down. Test the machine
and re-adjust, if necessary.
Figure 11.e - Tip up table & fit safety bar
Figure 11.f - Table load position magnet
Figure 11.g - Tip up table & fit safety bar
Figure 11.h - Table down magnet 2
