Del
Enter
Mother Board Configuration
CPU core speed = FSB x Ratio
If CPU Clock = 100MHz
Core / Bus ratio = 5
Then CPU core speed = 500MHz
Please follow manufacturer instruction for any expansion card
installed.
Refer to page 4 Fig. 2-1 to identify Pin No.1 connector on the
motherboard. (Black dot indicates Pin No.1).
Red line on the ribbon cable indicates Pin No.1.
Short Pin 2-3 for 3 to 5 seconds on JBAT to clear CMOS.
1. Turn on the computer.
2. Hold Down
key immediately after turning on the
computer.
3. Main Menu on Display (Pg. 15 Fig 3)
4. Select ‘Standard CMOS Feature’ and
press
5. Check and adjust date, time and Drive A/B configuration.
*We suggest you do not change the default setting unless you are very
well informed about all detail of the BIOS.
35
CPU Installation
Pg.8-9
Dram Installation
Pg. 8-9
Install Expansion Card
Pg.9
Connect cable, wires &
power supplies
Pg.
10-15
Bios Configuration
Clear CMOS
Pg. 6
Bios Setup
Pg. 6
