McIntosh C2600, Owner'S Manual

15

20. To save the new name, press and hold in the IN-

PUT Control until “SETUP: MEDIA BRDG ,  ON 

/ Rename” appears on the Front Panel Information 

Display. Refer to figure 20.

21. Exit the SETUP Mode by several presses of the 

INPUT Control.

Note: For convenience, an “Input Assignment Chart” 

on a separate sheet “Mc5A/5B” has been pro-

vided to keep track of changes.

Figure 15

 RENAME: BAL 1

    >MEDIA     <

Figure 16

 RENAME: BAL 1

    >MEDIA B    <

Figure 17

 RENAME: BAL 1

    >MEDIA BR    <

Figure 18

 RENAME: BAL 1

    >MEDIA BRD   <

Figure 19

 RENAME: BAL 1

    >MEDIA BRDG  <

The Output Settings provide the ability to change how 

the C2600 Output 1, Output 2 and Headphones func-

tion.

OUTPUT 1 and 2:

By defaut OUTPUT 1 and 2 are set to go On/Off by 

using the Front Panel OUTPUT 1 and 2 Push-buttons 

or by using the OUTPUT 1 and 2 Push-buttons on the 

Remote Control. If it is desirable to have OUTPUT 1 

and/or 2 always On regardless of the OUTPUT 1 and 

2 Push-button settings, perform the following:

1. Press and hold in the INPUT Control to enter the 

SETUP MODE. Refer to figure 2 on page 13.

2. Rotate the INPUT Control until “SETUP: Out

-

puts, (Hold INPUT)” appears on the Information 

Display. Refer to figure 21.

3. Press and hold in the INPUT Control until 

“SETUP:  OUTPUT 1, Switched” appears on the 

Display. Refer to figure 22.

4. Rotate the VOLUME (ADJUST) Control to change 

from the “Switched” setting to “Unswitched”. 

Refer to figure 23.

5. In a similar manner, perform steps 3 and 4 to 

change the OUTPUT 2 setting. Refer to figures 24 

and 25 on the next page.

Setup, con’t

Figure 14

 RENAME: BAL 1

    >MEDIA   <

Figure 13

 RENAME: BAL 1

    >MEDI    <

Figure 20

 SETUP: MEDIA BRDG

   On / Rename

Output Settings

Figure 21

 SETUP: Outputs

    (Hold INPUT)

Figure 23

 SETUP: OUTPUT 1

     Unswitched

Figure 22

 SETUP: OUTPUT 1

      Switched