McIntosh C2600, Owner'S Manual

16

The second example will use selection of Trigger 3 to 

activate when the BAL 1 Input is selected:

6. Rotate the INPUT Control to select “SETUP:  

TRIGGER 3, Main” appears on the Display.

7. Rotate the VOLUME (ADJUST) Control to select 

“SETUP:  TRIGGER 3, Input” appears on the 

Display. Refer to figure 33.

8. Press and hold in the INPUT Control until “SET

-

UP:  TRIGGER 3, Bal 1:  OFF” appears on the 

Display. Refer to figure 34.

9. Rotate the VOLUME (ADJUST) Control to select 

“Bal 1:  ON”. Refer to figure 35.

10. Exit the SETUP Mode by several presses of the 

INPUT Control.

Power Control Triggers 1 and 2

By default the Power Control TRIGger 1 and TRIGger 

2 are assigned to activate when Output 1 or Output 2 

is selected. TRIGger 3 and TRIGger 4 are assigned to 

function the same as the MAIN Power Control Jack, 

switching On/Off with the C2600. All four Triggers 

can also be reassigned to a given Input or Inputs.

In the first example, the Power Control Triggers 1 

and 2 will be assigned to MAIN:

1. Press and hold in the INPUT Control to enter the 

SETUP MODE. Refer to figure 2 on page 13.

2. Rotate the INPUT Control until “SETUP: Trig

-

gers, (Hold INPUT)” appears on the Information 

Display. Refer to figure 29.

3. Press and hold in the INPUT Control until 

“SETUP:  TRIGGER 1, Output 1” appears on the 

Display. Refer to figure 30.

4. Rotate the VOLUME (ADJUST) Control to select 

Main from the available additional selections in

-

cluding Output 2 or Input. Refer to figure 31.

5. In a similar manner, perform steps 3 and 4 to 

change the Trigger 2 setting from OUTPUT 2 to 

Main. Refer to figure 31 and figure 32.

Figure 29

SETUP: Triggers

   (Hold INPUT)

Figure 31

SETUP:  TRIGGER 1

       Main

Figure 30

SETUP:  TRIGGER 1

     Output 1

Figure 32

SETUP:  TRIGGER 2

     Output 2

Figure 33

SETUP:  TRIGGER 3

      Input

Figure 34

SETUP:  TRIGGER 3

     Bal 1: OFF

Figure 35

SETUP:  TRIGGER 3

     Bal 1:  ON

The C2600 Default Setting for using Headphones is 

to automatically mute all the Output Connectors when 

the Headphone Cable Plug is inserted into the C2600 

Front Panel HEADPHONES Jack. There are three 

available settings:

Mute All Outputs

Mute Main Output

Mute No Outputs

6. Rotate the INPUT Control until “SETUP: HEAD

-

PHONES,  Mute All Outputs ” appears on the 

Information Display. Refer to figure 26.

7. Rotate the VOLUME (ADJUST) Control to change 

the current HEADPHONES setting from “Mute 

All Outputs” to either “Mute Main Output” or 

“Mute No Outputs”. Refer to figures 27 and 28.

8. Exit the SETUP Mode by several presses of the 

INPUT Control.

Figure 25

 SETUP: OUTPUT 2

     Unswitched

Figure 24

 SETUP: OUTPUT 2

      Switched

 SETUP: HEADPHONES

  Mute No Outputs

Figure 28

Figure 26

 SETUP: HEADPHONES

  Mute All Outputs

Figure 27

 SETUP: HEADPHONES

  Mute Main Output