22
How to Operate the MA6600, con’t
Figure 42
MASTER RESET
-CLEARED-
Using Output 2
The MA6600 has provisions for connecting an exter-
nal Power Amplifier (to drive Loudspeakers in another
room) and an external sensor for remote operation of
the MA6600 from that room. With an external Power
Amplifier connected (as illustrated on the McIntosh
Connection Diagram separate sheet “
Mc1B”),
press
the Front Panel OUTPUT 2 Push-button or press on
the Remote Control the 2nd Push-button followed by
pressing the OUTPUT 2 Push-button to switch On or
Off the external Power Amplifier.
Reset of Microprocessors
In the unlikely event the controls of the MA6600 stop
functioning, the microprocessors can be reset by per-
forming the following:
1. Press the STANDBY/ON Push-button for approxi-
mately five seconds.
2. When the MA6600 cycles On then Off, release the
STANDBY/ON Push-button.
3. When the STANDBY/ON LED is illuminated
press the STANDBY/ON Push-button, the
MA6600 will resume normal operation.
Note: This can be performed with the MA6600 On or
in the Standby Mode.
Resetting the MA6600 to default settings
If it becomes desirable to reset all the adjustable set-
tings (Setup and Trim Settings) to the factory default
values, perform the following:
1. Press both the STORE/EXIT and OUTPUT 2
Push-buttons until the Front Panel Display indi-
cates “MASTER RESET” (refer to figure 42), then
release
the two
push-
buttons.
2. Press the
STANDBY/ON Push-button and the MA6600 will
resume operation.
SOURCE: CD1
15%
Figure 17
Figure 18
