19
2. Highlight the CLEAR button on screen and press the
SELECT push-button on your remote.
3. The password and verify fields will be cleared.
4. Highlight the SAVE button and press SELECT.
5. You will now be able to enter Setup without entering a
password.
Ethernet Settings
Ethernet is the preferred networking choice which provides
you with the best network performance and allows your
MS750 to act as a “server” to deliver your music collection
throughout your home network using the optional MS750
Music Players.
Ethernet networks require that you configure each de-
vice on the network with a valid “address”. These address-
es are usually configured automatically by your network
hardware. If your PC is setup using Dynamic or “DHCP”
addressing, you should most likely use the same for your
MS750.
Connect your MS750 to your Ethernet network using
the included Ethernet cable and then follow these steps to
specify your Ether-
net settings:
1. Press the SETUP
push-button on
the remote to
display the Setup
menu. Refer to
figure 1.
2. Select the
Network Menu.
Refer to figure 4.
3. Select the Eth-
ernet Settings
Menu.
4. Select Dynamic
for automatic
address configu-
ration or Static
if you want to
manually enter
your TCP/IP
address informa-
tion.
Enabling Password Protection
Optional Password Protection enables you to limit user
access to the Setup Menus. This is useful to lockout the
ability to change the global user settings and preferences.
Setting a System Password.
Follow these steps to setup a new system password:
1. Press the SETUP push-button on the remote.
2. Select the General menu. Refer to figure 1.
3. Select password protection.
4. Using the remote control, enter a 4 to 8 digit code into
the password
field.
5. Press the SE-
LECT push-but-
ton to highlight
the VERIFY
field.
6. Re-enter the same
password for veri-
fication.
7. Press the SELECT
push-button to
highlight the
SAVE button.
8. Press SELECT
again to save your
password and
enable Password
Protection on the Setup Menus.
Notes: 1. You must exit Setup and re-enter setup to acti-
vate the password protection.
2. If a user password is specified, you will be
prompted for your password whenever you press
the Setup push-button on the remote.
3. If the password entered matches the stored pass-
word, full access is granted to the user until the
next power off cycle.
4. If the password does not match, the user will be
asked 2 more times to enter the correct pass-
word. If after the third try the password still does
not match, the system will not allow the user ac-
cess to the Setup menus.
5. If the user does not specify a System Password,
access to the Setup menus will be allowed when-
ever you press the Setup push-button.
Removing a System Password
Follow these steps to remove the system password:
1. Press the SETUP push-button and enter your existing
system password.
SETUP, con’t
Figure 1
Figure 4
Summary of Contents for MS750
