29
Sub Crossover
The MX136 incorporates a built-in Electronic Crossover.
The Crossover will redirect all of the audio frequencies be-
low the crossover frequency setting to the Subwoofer and
all the frequencies above the setting to the appropriate re-
maining Home Theater Loudspeakers. The default setting
for the SUB Crossover frequency setting is 80 Hz, which is
the correct frequency for most Home Theater Loudspeaker
Systems. Refer to figure 8 and perform the following steps
to change the setting.
6. Using the Up
or Down
directional push-buttons,
select SUB Crossover from the SPEAKER SIZE On-
Screen Menu, followed by pressing the Left or
Right directional push-buttons to change the cross-
over frequency to the desired setting.
Notes: The range of adjustment is from 60Hz to 120Hz in
10Hz increments. When the Input Source is Analog
and the Surround Mode is set to STEREO (the
Alphanumeric Front Panel Display will indicate
PURE STEREO) the crossover frequency will default
to 80Hz.
7. Next perform the MC Bass Mode adjustment below or
if no adjustment is needed, then continue to the
SPEAKER TIME DELAY Settings. If you do not wish
to perform SPEAKER TIME DELAY adjustments at
this time, select MAIN MENU from the menu. The
MAIN SYSTEM SETUP Menu will reappear on the
Monitor/TV screen and proceed to the next step.
8. Select EXIT from the MAIN SYSTEM SETUP Menu.
If you are satisfied with the changes that you may have
made, select YES to save those changes or NO not to
save them. The MX136 will then return to normal op-
eration. Refer to figure 7 on page 27.
SETUP, con’t
Loudspeaker
Default Setting
New Setting
Front (L&R)
Small
Center
Small
Surround (L&R)
Small
Back Surround
Small 2
Subwoofer
Yes
Sub Crossover
80Hz
MC Bass
Off
Loudspeaker Size
MC Bass Mode
When a Home Theater System contains Loudspeakers that
are refered to as Large, the Bass Management Circuitry will
direct all the Low Frequency Sounds away from the
Subwoofer and to the Large Loudspeakers. With the MC
BASS MODE set to ON the Low Frequency Sounds are
sent to both the Large Loudspeakers and to the Subwoofer,
thus increasing the total low frequency output of the Home
Theater System. The default setting for the MC BASS
MODE is OFF. Refer to figure 8 and perform the following
steps to switch it On.
Note: The MC BASS Mode is only active when the Source is
either a Two Channel Analog or Digital Signal.
9. Using the Up
or Down
directional push-buttons,
select MC BASS MODE from the SPEAKER SIZE
On-Screen Menu, followed by pressing the Left or
Right directional push-buttons to activate the circuit.
Select MAIN MENU and the MAIN SYSTEM SETUP
Menu will reappear on the Monitor/TV screen.
10. Next continue to the SPEAKER TIME DELAY Set-
tings. If you do not wish to perform SPEAKER TIME
DELAY adjustments at this time, select MAIN MENU
from the menu. The MAIN SYSTEM SETUP Menu
will reappear on the Monitor/TV screen and proceed to
the next step.
11. Select EXIT from the MAIN SYSTEM SETUP Menu.
If you are satisfied with the changes that you have
made, select YES to save those changes or NO not to
save them. The MX136 will then return to normal op-
eration. Refer to figure 7 on page 27.
Summary of Contents for MX136
Page 23: ...23 Notes ...
