PBX
gateway
QIG Page 17 G-6000G-SMM
IP Device (RVP_IP)
Introduction
This section of the manual provides the necessary information to configure the
PBXgateway for connection over an IP network.
Figure 8. Typical Installation
Prerequisites for Configuration
!
Both units must be installed properly and the network link between both devices, must be operational.
!
The network administrator must assign IP address information for both Gateway and Remote units.
!
The network administrator must provide the remote users with User ID’s and Connect Passwords (if
assigned) or port numbers if not using User ID’s.
Basic Configuration
You must ….……
to…………
Default settings
Refer to System Admin.
Guide …….
Set the Phone Port
compression algorithm for
all active phone ports.
Provide adequate
bandwidth for all users.
ADPCM 32 (on
all phone ports)
Chapter 4 -
Port set up
Disable WAN ports
Disable WAN ports that
are unnecessary for
RVP_IP.
WAN 1 – Enabled
WAN 2 -Disabled
Chapter 4 -
WAN set up
Tune Jitter Delay &
Packet Size
Tune voice parameters to
match IP Network
characteristics.
Jitter Delay: 0
Packet Size: 2
Chapter 4 -
Setting Voice
Parameters
Set IP parameters
including;
"
"
"
"
IP Address
"
"
"
"
Subnet
"
"
"
"
Default Router
Allow the Gateway to
communicate over the IP
network.
None
Chapter 4 -
Setting IP
Parameters
Table 8. Basic Configuration Steps
Punch Block
IP Network
PBX
Branch Office
Corporate Facility
Punch Block
PBX
gateway
EXT
ender 6000
Router
Router
LAN
LAN
EXT
ender 4000
