Care
Point:
Use a plain M14 half nut and wind
onto the upper and lower ball joint
threads. Torque these nuts (5, 6)
to M14 60 Nm . Once torque has
been achieved, remove slave nuts
and fit specified nuts (5, 6). Torque
these nuts (5, 6) to M14 100 Nm
.
Care
Point:
If refitting or renewing camber
tophat in upright, ensure Loctite
222 is used on the position fixing
and a torque value of 1.2 Nm is
applied.
1.
Install components in reverse order.
2.
Check chassis geometry. AA-
RM-03B03-01-002 - Perform a wheel
alignment check
Care
Point:
Once vehicle is on ground.
3.
Apply pressure to top of wheel towards
vehicle. If excessive inward movement of
wheel is present, the upper ball joint has
failed. The wishbone will require replacing.
Torque settings
FG03 Chassis / B01 Front Suspension / Front Suspension LH / AA-RM-03B01-02-004 - Remove/install upright - Front
Description
Dimension
Value
Nut Track rod - Upright
M12
70 Nm
Half Nut wishbone - Upright
M14
60 Nm
Nut wishbone - Upright
M14
100 Nm
127
Summary of Contents for MP4-12C
