- 6 -
How to Charge the Batteries
Caution: Only use a battery charger designed for the machine. Failure to do so
can result in damage to the batteries.
Plug the charger red plug to the machine charging plug located near the key switch. Plug
the other charger plug to 220V/120V wall outlet. The charger will automatically begin to
charge the batteries.
How to Install the Squeegee
1.
Put squeegee Release Handle (6) in the UP and locked position.
2.
Position the squeegee blade assembly on the swing arm. Make sure the guide wheels
face the rear of the squeegee.
3.
Place the solution recovery hose (10) over the nozzle. Make sure it fits tight.
How to Install Pad Holder and Brush
1.
Raise the brush pad by stepping on Brush Lift Pedal (8) at the rear of the machine.
2.
With the pad holder/brush in lifted position, insert it into the plate underneath by
turning it counter-clockwise until it locks.
How to Fill the Solution Tank
1.
Open the solution fill cover .
2.
Fill the tank (17) with the desired level of clean water.
3.
Add cleaning chemical.
4.
You can also insert the tube into hole(16) to add water.
Do not overfill.
How To Operate The Machine
1.
To turn the power on, turn the key switch (5). The
power indicator (f) will light up.
2.
Power indicator:
g : green light means full power;
h : yellow light means not full power;
i : red indicator means few power, you need to recharge
the battery ASAP
3.
To turn on the brush motor, vacuum motor and release
the water, press the switches (c,d,e).
4.
Lay down the squeegee release level (6), press the
suction motor button(c), the squeegee will start to work;
when you finish your work, press the button(c), the
suction motor will be stopped, then lift the squeegee up.
5.
Move the knob A into"
" position, the machine will
move forward automatically; while in "
" position,
the machine will reverse automatically.
