Quickstart
This is a
Thermostat
for
Europe
. To run this device please connect it to your mains power
supply.
MCOHome Fan Coil Thermostat is a Z-Wave enabled device for indoor temperature control.
To protect yourself and others from danger and to protect the device from damage,
please read the safety information before using it.
You can find further information in the device manual.
Step 1: Remove the steel frame from the device, and secure it onto the junction box
with two screws.
Step 2: Insert all wires into the right terminals and tighten screws. The wiring diagram
is shown below.
Step 3: Attach the wired device on "A" points of the steel frame as shown first, and
then push the whole device into junction box.
Step 4: Confirm the device is well mounted, power on and it is ready to operate.
