6
McQuay IM 672-3
Installation Guidelines
Panels, Frame Channels, and Doors
Panel Removal
To remove a side or top panel, remove the flat head Torx 30
fasteners along the sides of the panel. Lift off the panel after
removing all fasteners.
Frame Channel Removal
Frame channels that run the length of the unit along the top can
be removed to allow access to both the side and top of the unit.
To remove the frame channel, first remove the side panel(s).
Once the side panel is off, remove the flat head Torx 30
fasteners in the corner of the frame channels. Then pull the
frame channel out the side. Remove any panel screws that are
within one inch of the of the frame since they are engaged into
the gasketed flange of the frame. See Figure 14.
Figure 14: Removing panel screws
Fan Section Doors
Note –
Opening fan section doors requires using a 1/2" socket
wrench, which satisfies ANSI standards and other codes
that require the “use of tools” to access compartments
containing moving parts or electrical wiring. See
Figure 15.
1
Remove padlock if one is present.
2
Insert 1/2" socket into cup and rotate 1/4 turn clockwise as
shown in Figure 15:. If the cup and handle are on the left
side of the door, rotate 1/4 turn counterclockwise.
3
Rotate the door handle 1/4 turn clockwise and then 1/4 turn
counterclockwise to release any internal pressure or
vacuum and open the door. If the cup and handle are on the
left side of the door, rotate the door handle 1/4 turn
counterclockwise and then 1/4 turn clockwise.
4
To prevent air leakage, tighten the door panels by adjusting
the jam nuts.
Figure 15: Opening fan section door
CAUTION
SHARP EDGES AND COIL SURFACES
are a potential injury hazard. Avoid contact with them.
ATTENTION
Les bords tranchants et les surfaces des bobines sont un
risque de blessure. Ne les touchez pas.
R e m o v e a n y
p a n e l s c r e w s t h a t
e n g a g e f r a m e
R e m o v e p a n e l
t o r e m o v e f r a m e
CAUTION
DO NOT attempt to rotate the cup.
Damage to the unit will occur.
ATTENTION
NE PAS tenter de faire tourner la cuvette (cup).
Ceci va dendomagger l’unité.
OPEN
View from inside door
Jam
Nuts
Do Not Rotate Cup
