MCS-OEM KEYPAD
Installation Instructions
5580 Enterprise Pkwy. Fort Myers, FL 33905
Office: 239-694-0089 Fax: 239-694-0031 www.mcscontrols.com
Revision 2018-12-21
Instructions for mounting using a Gasket Seal (not supplied)
Package contains the following:
MCS-KEYPAD-OEM - color black
1. Cut hole in your enclosure using MCS-KEYPAD OEM-Template,
available at;
https://mcscontrols.com/micros.html#MCS-MAGNUM
2. Use the
8 holes
shown in photo to mount the keypad, use #6/32 thread size x 0.500 long bolt and Keps nut.
NOTE:
ON THE TOP HOLE #2, USE A ‘ACORN NUT
TO AVOID DAMAGING RIBBON CABLE. (not supplied)
3. Top-center & bottom center mounting holes on OEM keypad MUST be used when water tight seal is
required.
CAUTION
When mounting this unit, please do not pinch, crease or
create sharp folds in ribbon cables.
Before installing, make sure the LCD ribbon cable is tucked in
to avoid damaging when mounting
USE THIS HOLE TO SECURE A TIGHT SEAL WITH THE ENCLOSURE
SECURE WITH ACORN NUT ON BACK
USE THIS HOLE TO SECURE A TIGHT SEAL
WITH THE ENCLOSURE
1
8
7
3
4
5
Ground Tab
When mounting the Keypad, fold
over the black ground tab and
place a washer over the black
tab. Fasten the keps nut on the
Keypad back as shown below.
#6/32 thread size x 0.50
bolt and Keps nut.
USE A ‘ACORN’ NUT
ON #2 HOLE TO AVOID
DAMAGING RIBBON
CABLE
(see below)
2
6
Gasket Material
(not supplied)
HT-800 Medium
Cellular Silicone
