MCZ CONTROL - MODEM GSM
2
Modem GSM ACTIVE SYSTEM
MCZ GROUP S.p.A. all rights reserved
INTRODUCTION
Specifications can be altered without any pre-warning.
Some terms used in this document can be other
companies' factory brands and are mentioned as
examples without violating the legitimate rights of the
owners.
Even though the content of this manual has been
accurately controlled, MCZ cannot be held responsible
for any damage or loss derived from information
contained in the present document.
GUARANTEE
MCZ guarantees its products for two years from the
date of manufacturing and reserves the right to repair
and/or replace the products or components that are
faulty due to the material used and/or manufacturing
process or that are non-compliant with the
specifications or order. No further explicit or implicit
guarantee nor any cover for loss revenue is provided.
In no cases can MCZ be held responsible for any
consequences or damage resulting from the use
of its products.
MAINTENANCE
Handle the SIM card with care. Do not bend or scratch
the SIM card and avoid exposing it to static electricity.
Do not use any chemical substances to clean the SIM
card or MczControl.
Do not remove any cover or markings from MczControl.
SAFETY WARNINGS
Do not install MCZControl close to medical equipment
like pacemakers or hearing aids. MCZControl can
interfere with the operations of this equipment.
Do not install MczControl close to petrol stations, fuel
depots, chemical plants or explosion sites where
MCZControl can disrupt the operation of technical
devices.
MczControl can generate interference if deployed close
to televisions, radios or personal computers.
In order to avoid potential damage it is recommended
the use of tested and specified accessories like those
compatible with MczControl. No accessories are
covered by the warranty.
MczControl is subject to a complete functional test. The
specifications are based on the characteristics of the
tested sample units and do not refer to measurements
carried out on each single unit.
The warranty does not cover improper use of the
equipment.
PRODUCT DESCRIPTION
MczControl is a civil GSM terminal for the supervision
and control of MCZ stoves through the use of advances
functions available through the GSM network.
The interfaces, connections and integrated SIM card
decoder make this rapid use and simple GSM terminal
in a domestic environment.
TECHNICAL CHARACTERISTICS
•
Dual-band EGSM 900/1800 MHz
•
Sensitivity better than -106dBm
•
Output power:
o
Class 4 (2W) for 900 MHz
o
Class 1 (1W) for 1800 MHz
•
Integrated antenna
•
Powered by an internal 340mAh Li-Ion battery
•
External power for battery charging: 9÷24 Vdc,
6÷21 Vac
•
Average consumption of battery during
charging: 70mA
•
1200 baud optoisolated asynchronous serial
communication port
•
No. 2 status indicator leds, no. 1 reset button
•
ABS container (UL 94 HB)
•
Level of protection EN-60529: IP30
•
Dimensions: L=102mm, W=54mm, H=30mm
•
Indicative weight: 180 g
•
Operating temperature: -10 ÷ +55°C
INSTALLATION
MczControl must be installed by qualified personnel.
MczControl can be used only on specific models of MCZ
stoves and specifically only on those equipped with
ACTIVE SYSTEM technology
MczControl uses an internal rechargable Li-Ion battery:
please adhere to the specific guidelines.
The cable connecting MczControl to the stove must be
that provided by MCZ: in cases where the supplied
cable is not of the correct length, purchase a cable of
greater length from the catalogue. In the connecting
cable the voltages and the signals are at Safety
Extremely Low Voltage (SELV)
MczControl must be installed using the appropriate
bracket provided at the rear of the stove. In cases
where the location does not allow a good GSM
connection wall-mount it using, where necessary, a
cable of greater length (non-standard accessory).
Electrical safety in the case of a fault is guaranteed by
an internal fuse and appropriate mechanisms provide
protection against external power surges.
