B
A
11
2-INSTALLATION
Technical Dept. - All rights reserved - Reproduction prohibited
FOREWORD
The installation position must be chosen according to the room, smoke extraction system and flue. Check with local authorities whether
there are any restrictive regulations in force regarding the combustion air inlet, the smoke outlet system, the flue or the chimneypot. The
manufacturer declines all responsibility in the event of installations that do not comply with the laws in force, incorrect room air exchange,
electrical connection non-compliant with the standards and inappropriate use of the appliance. The installation must be carried out by
a qualified technician, who must issue a declaration of conformity of the system to the purchaser and shall assume full responsibility for
final installation and consequent good operation of the product.
In particular one must ensure that:
•
there is a suitable combustion air inlet and smoke outlet in compliance with the type of product installed
•
other stoves or devices installed do not cause negative pressure in the room where the product is installed (for sealed appliances only,
a maximum of 15 Pa of negative pressure in the room is allowed)
•
when the product is switched on there is no reflux of smoke in the room
•
smoke extraction takes place in full safety (sizing, smoke seal, distances from flammable materials...).
We especially recommend checking the data plates of the flue for the safety distances that must be observed in the
presence of combustible materials and the type of insulating material to be used. These indications must be followed
strictly to prevent serious harm to people and to the integrity of the home.
Installation of the appliance must ensure easy access
to clean the appliance itself, the smoke outlet pipes and the flue.
It is forbidden to install the stove in rooms with a fire hazard.
Installation in studio flats, bedrooms and bathrooms is only permitted with sealed or closed appliances equipped with
suitable combustion air ducting directly outside. Always maintain adequate distance and protection in order to prevent
the product from coming into contact with water.
If there are several appliances installed, the external air inlet must be sized accordingly.
MINIMUM DISTANCES
It is recommended to install the stove detached from any walls and/or furniture, with a minimum clearance to allow effective aeration
of the appliance and a good distribution of heat in the room. Comply with the distances from flammable or heat-sensitive objects (sofas,
furniture, wood panelling, etc.) as specified below. The frontal distance from flammable materials must be at least as specified in the
product’s technical data table.
If there are particularly delicate objects such as furniture, curtains or sofas, increase the stove distance accordingly.
If the floor is made of wood, it is recommended to fit a floor protection sheet in compliance with the standards in
force in the country of installation.
AKI
HYDROMATIC 16/24 M1
Non-flammable walls
Flammable walls
A = 2 cm
B = 5 cm
A = 2 cm
B = 20 cm
If the floor is made of combustible material, it is recommended to use a protection made of non-combustible material (steel, glass...) that
also protects the front from any falling combusted material during cleaning operations.
The appliance must be installed on a floor with adequate load capacity.
If the existing construction does not meet this requirement, appropriate measures must be taken (for example a load distribution plate).
