x
1
2
F
G
L
H
55
35-MAINTENANCE AND CLEANING
Technical Dept. - All rights reserved - Reproduction prohibited
PERIODIC CLEANING PERFORMED BY A QUALIFIED TECHNICIAN
EXTRACTING THE PRODUCT
To perform maintenance of some devices and cleaning of certain parts, it is necessary to extract a part of the product from its housing. The
movable part is fitted on sliding guides, which promote the handling process. Before extracting it, release the handle lock following the
instructions in this manual. The guides are fitted with end-of-travel devices that block the movable part when fully extracted.
ATTENTION: THE PRODUCT MUST ONLY BE EXTRACTED WHEN THE STRUCTURE IS COLD. THE POWER IS AUTOMATICALLY
TURNED OFF WHEN THE PRODUCT IS EXTRACTED.
When the movable part is put back in place, make sure the machine is locked to the fixed part by closing the handle or the
mechanical lock (Basic version). Forgetting to do so may result in the product not working due to leaking soot.
CLEANING THE HEAT EXCHANGER
Clean the exchanger when the stove is cold. Open the firebox door and proceed as follows:
•
loosen the two screws “x” fastening the deflector so that the top calorite “H” can be removed
•
extract the left cast iron side panel “F”
•
extract the right cast iron side panel “L”
Lift (1) and tilt (2) side panels “F” and “L” to
remove them
•
hold the calorite unit “H” with one hand and
use the other to remove the screws “x”
•
take the top calorite “H” out. Lower it to
remove it from the supports and take it out.
•
remove the back “G” (2)
Reassemble the pieces following the sequence
in reverse order.
Attention! Before reassembling the
pieces, make sure the calorite “H” is
intact, if in doubt replace it.
Summary of Contents for VIVO 90 COMFORT AIR 11 M1
Page 36: ...36 28 SETTINGS MENU SUMMER WINTER Option to select the operating season ...
Page 66: ......
Page 67: ......
