CSP
−
902RFM207E
−
1
ROTORCRAFT FLIGHT MANUAL
MD900 (902 Configuration with PW 207E)
Normal Procedures
FAA Approved
Reissue 2
Original
4
−
25
IIDS
CHECK FOR NORMAL INDICATIONS
NOTE
:
If any abnormal indications are observed, i.e. low transmission/engine oil
pressures, shut down engine.
Repeat starting procedure for second engine
NOTE
:
Do not start second engine until at least 60% N
R
is attained on the first engine.
GPU start only:
L GEN/R GEN
ON
GPU
DISCONNECT
Yellow GPU indicator light (aft mounted battery only)
OUT
4
−
6.
ENGINE RUNUP
Electrical master panel:
Avionics
ON, AS DESIRED
Engine control panel:
L ENGINE and R ENGINE
FLY
4
−
7.
BEFORE TAKEOFF
Cyclic response check:
Move cyclic stick and observe rotor tip for correct movement.
Collective friction
AS DESIRED
Primary and secondary IIDS displays
CHECK ADVISORIES
Utility Panel:
PITOT HEAT (if installed)
AS REQUIRED
NOTE
:
Turn pitot heat ON when visible moisture conditions prevail and OAT is 5
°
C and
below.
IPS switch (if installed)
AS DESIRED
CAB HEAT
AS DESIRED
Summary of Contents for MD900 Explorer
Page 4: ......
