CSP
−
902RFM207E
−
1
ROTORCRAFT FLIGHT MANUAL
MD900 (902 Configuration with PW 207E)
Optional Equipment
Moving Map Navigation Systems
Original
10
−
79
FAA Approved
Reissue 2
f927
−
109
Figure 10
−
29. AI
−
500 Monitor
Table 10
−
8. AI
−
500 Control Functions
Control
Function
POWER
When the Power button is depressed to ON the adjacent power indicator lights to
green. To turn the power off, depress the POWER button again.
VIDEO SELECT
The two buttons, identified as IR/CCD or MAP select their respective video source.
The selected button lights in green when depressed.
MENU
Pressing the MENU button provides a screen menu which allows the operator to
adjust the following levels:
CONTRAST: (Picture Contrast) Adjusts the picture contrast. Decreasing the value
lowers the contrast, and increasing the value raises it. Adjustable range: -30 to
+30
BRIGHTNESS: (Picture Brightness) Adjusts the picture brightness. Decreasing
the value makes the picture darker, and increasing the value makes it brighter.
Adjustable range: -30 to +30
SHARPNESS: (Picture Sharpness) Adjust the picture sharpness. Decreasing the
value makes the picture softer, and increasing the value makes it more sharp. Ad
justable range: -30 to +30
CHROMA: (Picture Chroma) Adjusts the picture chroma. Decreasing the value
makes the picture lighter, and increasing the value makes it deeper. Adjustable
range: -30 to +30
PHASE: (Picture phase, NTSC only) Adjusts the picture phase. Decreasing the val
ue makes the picture more reddish and increasing the value makes it more green
ish. Adjustable range: -30 to +30
COLOUR SYSTEM: (Colour System) Displays the colour system (NTSC or PAL)
used by the video equipment.
POWER SAVE: (Power Save) With the power save function set to ON (active) the
monitor automatically enters standby mode when no video signal is input. When
the power save function is active the POWER indicator blinks in green. When a
video signal is input, the power save function becomes inactive and the monitor is
restored to normal operation. Pressing any buttons on the front operation panel
also sets the power safe function to inactive.
The power save function becomes active when no video signal is input for over 30
seconds.
COLOUR SWITCH: Turns the picture into black and white for checking the white
balance.
The MENU + and - buttons control the settings for each of these controls.
Summary of Contents for MD900 Explorer
Page 4: ......