Category A Operations
Takeoff and Landing Procedures
CSP
−
902RFM207E
−
1
ROTORCRAFT FLIGHT MANUAL
MD900 (902 Configuration with PW 207E)
FAA Approved
Reissue 2
Revision 4
11
−
24
11
−
3.7. CONTINUED TAKEOFF
−
CONFINED HELIPORT
ACCELERATE
TO V
Y
TDP
CLIMB AT V
Y
f927
−
044
−
1
100FT
(30.5M)
300FT (91.4M)
Figure 11
−
3.13. Example
−
Confined Heliport CTO Profile and Distance to Clear
30ft/9.1m Obstacle
Determine allowable weight limit from Heliport/Elevated Helipad WAT chart
(Ref. Figure 11-2.3.).
Determine TDP (Ref. Table 11-3.1)
Power assurance check
PASS
Pre takeoff check
PERFORM
Heliport elevation
NOTE HELIPORT ELEVATION WHILE AT FLAT PITCH
Vertical Takeoff
ESTABLISH SIGHT PICTURE BY CLIMBING VERTICALLY TO IP HAT 100 FT
AND CONTINUES REARWARD CLIMB UNTIL THE FAR EDGE OF THE
HELIPORT IS JUST ABOVE THE SIGHT PLANE OF THE INSTRUMENT
PANEL GLARE SHIELD AT 130 FT TDP HAT (REF. FIGURE 11-3.13)
.
At TDP
PITCH THE AIRCRAFT NOSE DOWN, ACCELERATE TO V
TOSS
, AND
REDUCE COLLECTIVE TO PREVENT ROTOR DROOP WHILE ADJUSTING
POWER TO 2.5 MINUTE OEI LIMIT AND CLIMB OUT AT V
TOSS
.
From 200ft/61m to
300ft/91.4m AGL
AT 230FT/70.1M AGL (REF. TABLE 11-3.1), ACCELERATE TO V
Y
AND CLIMB
TO 1000FT/305M AT OEI MCP.
Summary of Contents for MD900 Explorer
Page 4: ......