www.marketdirect.com.au
Ph: 1300 494 494
68
Mechanical Maintenance
Maintenance is essential to keep your caravan in a safe and usable condition. Caravans are no different to any other
motor vehicle and require servicing at regular intervals which may vary according to use and the environment in which
it is used. The service schedule outlines the service intervals for safe travelling and your owner obligations under our
warranty policy. Servicing should always be carried out by a competent person with relevant experience.
WARNING:
• Never work beneath the caravan while suspended on a jack. Always use “Jack Stands” with an adequate SWL.
• Always use dedicated jacking points
• 240volt appliances and wiring must only be serviced and repaired by a qualified tradesperson.
• Gas plumbing must only be serviced and repaired by a qualified gas fitter
Hitch
Cruisemaster DO35
To ensure a long service life we recommend the following periodic maintenance procedures.
1. Always keep Tow Pin and Universal mating surfaces clean and lightly lubricated.
2. Check condition of Tow Pin O-Ring and replace if necessary (Part No. 18D-DO35-101).
3. Regularly lubricate grease points with multi-purpose grease.
4. Periodic adjustment of Slotted Nut & Pin may be required of coupling head loosens excessively and should be a
competent person.
5. Flush with clean water if locking mechanism does not open fully due to dirt ingress.
Ball Bearing Slides
To lubricate and protect from corrosion the ball bearing slides should be lubricated with a small amount of general pur-
pose grease every 6 months.
Wheels and Tyres
Tyres should be checked for damage prior to each trip. Inspect for adequate tread depth and any damage particularly
to sidewalls. Wheel nuts must be checked with a torque wrench. When picking up your new caravan check the wheel
nut torque at 50, 100, 200 and 500km. Check before each trip and daily when travelling for longer periods. Do not over
tighten, always use a torque wrench to ensure accuracy.
Brakes
The electric brakes on your caravan are a drum type. Drum brakes require regular adjustment to ensure even pad
wear and proper performance. This is an important safety item. The recommended interval for checking adjustment is
5000km.
Bearings and Seals
The Timken bearings in your caravan are protected with a rubber seal on the rear of the drum and a friction fit bearing
cap on the front. Normal use without encountering water crossings these should be services every 5000km.
Summary of Contents for XT17-HRT
