Page 9
Hazard generated by pieces of wood being hurled away!
1. Always place curved logs on the feed rocker with the curved side facing the
saw blade.
2. Do not jam the logs to be cut.
3. Do not attempt to stop the saw blade by pushing the workpiece against its
die.
4. Always use sharp saw blades.
5. If in doubt, inspect the logs for foreign matter (e.g. Nails or screws).
6. Never cut several logs at the same time-- and also no bundle containing
several individual pieces. Risk of personal injury if individual pieces are caught in
the saw blade uncontrolled.
4.1 Cutting
1. Start machine and let the motor reach full speed.
2. Place a log on the feed rocker.
3. To make the cut, push the feed rocker with both hands at the handle towards
the saw blade:
- Exert only so much pressure that the motor speed does not fall off.
- Push feed rocker forward until it hits the stop.
4. Return feed rocker completely to the starting position.
Note:
If the log was not completely separated, turn it over and repeat, the cutting
operation from the opposite side (reversing cut).
5. Remove the cut off piece from the feed rock- make next cut...
6. If no further cutting is to be done immediately afterwards, turn machine OFF.
5.Care and maintenance
Prior to all servicing:
- Turn machine OFF;
- Wait for saw blade to complete stop;
Summary of Contents for 15HP
Page 12: ...Page 12 ...
Page 13: ...Page 13 ...
Page 14: ...Page 14 ...
Page 16: ...Page 16 01228 712121 www mdlpowerup com info mdlpowerup com ...