Assembly Instructions 14 X 20 X 9 Party Tent Style
V2.0 14 X 20 X 9 Size
The guy ropes (#16) provided should be attached or tied
to the frame only, ensuring that they are all pegged
directly in line with the seam or pole to which the will
apply tension and support. Once this is achieved tighten
the adjusters so that equal tension is applied to each guy
point.
If these are not already attached, we suggest that
securing straps be used to guard against sudden
changes in weather and gusts of wind.
DISMANTLING PARTY TENT
Simply reverse the instructions above, again taking
particular care in windy conditions to prevent the tent
from becoming damaged and avoiding personal injury.
Please note that the stakes should be removed by either
using a tent stake extractor or more simply by using
another peg. Do NOT pull them out by using the guy
rope or the tents’ fabric.
Door Hold Ups
All MDM Products doors are manufactured with a pocket
on the bottom edge along the width axis. A ½” plastic or
metal EMT tubing can be inserted into the pocket and
trimmed to fit. Four(4) Bungee Cords (#13) are provided
to be used as Door Hold Up straps.
Bungee Hold Ups support End Panel Fabric in Up
Position
PROPER CARE IN USE
Think Safety First
Keep the exit(s) clear & free from obstruction to prevent
accidental damage to occupants and the party tent in an
emergency.
To help keep the doors closed it may be necessary to
cross over the stake points at the base of zippers. Avoid
walking on the zippers and keep them free from dirt, as
this will maintain their smooth operation. Should the
zippers become difficult to operate, do not force them.
Adjust the stakes/guying of the tent to ease the pressure
on the zippers and lubricate with a silicon or similar
lubricant to maintain their smooth operation.
Periodically check each stake point or securing straps
and re-adjust as necessary, especially during/after windy
or stormy weather.
FIRE WARNING
A Fire Retardant treatment has been applied to the
fabric of this tent that will significantly reduce the rate of
flame spread, but the tent is still flammable.
•
Keep all open fires, barbecues, or heaters at least 20
feet away from all tent fabrics.
•
Keep all open flames and heat sources well away from
all tent fabrics. Do not allow smoking of cigarettes,
cigars, pipes, or any open flames inside or near party
tents.
•
Do not refill stoves or change fuel cartridges inside or
near to the tent.
•
Never leave heating, lighting or cooking appliances
unattended in the vicinity of the tent.
STORAGE, MAINTENANCE, & CARE
NEVER store the tent unless it is completely dry. Storing
when damp allows the formation of mold and mildew,
which will rot natural fibers & damages the waterproof
coating to the fabric and leaves indelible stains. Poles
and fitments, including tent pegs, should be cleaned,
dried and stored separately from the main tent parts.
These poles may be given a light coating of petroleum
jelly to help prevent corrosion.
Every couple of days when in use the unit should be
completely inspected internally and externally to make
certain the unit remains properly installed and secured.
Particular attention should be paid to:
