Appendix F Command Set Description
MX-2100/2104
Installation and Operation Manual
F-32
Commands
2. After the desired parameter values are selected, press ENTER.
The next line of the system parameters data form is displayed:
SLOT: 3
4 OPTION
TYPE (DB):
KML.1
KML.10
---
3. After the desired modules are selected, press ENTER.
The next line of the system parameters data form is displayed. A typical
line is shown below:
SLOT:
1 2
3 4 5 6
TYPE
(DB):
--- KLS.2 --- --- KLS.2 ---
If you want to include in the MX-2100 database a module that is not physically
installed, e.g., to preprogram parameters so when the module is installed, it
will start immediately to operate in the desired mode, select the desired
module type for each empty slot as mentioned above.
You can select a
module type only if the slot is empty. If the slot is not empty, it
automatically shows the type of the module physically installed in the slot.
If the installed module is changed, the module type is automatically
changed in the database.
4. After the desired modules are selected, press ENTER.
The last line of the system parameters data form is displayed:
SLOT:
7 8 9 10
11
12
TYPE
(DB): --- --- --- --- --- ---
5. After the desired parameter values are selected, press ENTER to end.
DISCONNECT SWITCH
Purpose
Disconnects the remote MX-2100 from the local MX-2100’s main link over the
ISDN switch line when the following is true:
•
The MX-2100’s main link is configured to manual operation and switch mode
(refer to
DEF ML
command).
•
The system is in switch mode (refer to
DEF SYS
command).
