Appendix F Command Set Description
MX-2100/2104
Installation and Operation Manual
F-28
Commands
DEF SP
Purpose
Assign values to supervisory port parameters. See section
Supervisory Port
Configuration Parameters
in Appendix E for parameter description and allowable
ranges, and section
Configuring the SP Parameters
in Chapter 3 for practical
selection recommendations.
Format
DEF SP
Use
1. Type
DEF SP <ENTER>
The supervisory port parameters data form is displayed. The data form lists
the parameters on two separate lines. A typical complete form is shown
below. The form presents the current parameter values as defaults.
SPEED DATA
PARITY
INTERFACE
CTS
DCD_DEL
DSR
9.6 kbps 8
NONE
DCE
ON
10
ON
POP_ALM PWD LOG_OFF
AUXILIARY_DEVICE
NO NO
NO
NMS_SLIP
2. Change parameters as follows:
Bring the cursor to the beginning of the first field to be changed by
pressing the space bar.
To change the selected field, press F or B to scroll among the available
selections. When the desired selection is displayed, press the space bar
to move to the next field.
3. After the desired parameter values are selected, press ENTER to end.
MX-2100 will display the time and date fields, followed by the MX-2100 prompt.
In addition to the parameters listed in Supervisory Port Configuration Parameters
in the Configuration Parameters appendix,
lists parameters which can be
programmed only from the terminal:
Table F-4. Terminal Programmed Parameters
Designation
Function
Values
SPEED
Selects the data rate.
9.6, 19.2, 38.4 or 57.6 kbps
CTS
-
ON
The CTS line is always ON (active).
=RTS
- The CTS line follows the RTS line.
DCD_DELAY
With the MX-2100 supervisory port
defined as DTE, indicates delay (in
msec) between DCD=ON and the
sending of data.
0, 10, 50, 100, 200, 300 msec
