Top hat rail housing GSV-1H
The measuring amplifier GSV-1H is available with voltage outputs ±5V, ±10V and current
output 4...20mA.
The force sensor is connected to terminals 1 to 4.
The voltage supply (11-28V) is connected to terminal 5 and 8 (ground).
For zero setting, terminal 6 is connected to the mains supply or a control signal between 5
and 24 volts is applied.
The amplification can be switched 1-2-4-10-times with internal jumpers.
If the input signal is negative, output follows up to 0mA the input signal, beyond it remains
at 0mA.
Pin Configuration
Pins
1 / 2
+U
S
−
U
S
Bridge supply (for sensor input, "excitation“, "input“)
3 / 4
+U
D
−
U
D
Differential input (for sensor output “output“, sensor signal)
5 / 6
+U
B
Tara
DC voltage supply
+12V or +24V
Steuereingang Nullabgleich
7 / 8
U
A
GND
Analog output
Masse
Note: The ground of the voltage supply is connected to terminal 8.
Dimensions
Instruction Manual
7
GSV-1H:
Depth: 114.5mm
for installation on mounting rails according to
EN50022
Summary of Contents for GSV-1
Page 3: ...Strain Gage Measuring Amplifier GSV 1 Instruction Manual 3...
Page 19: ......
