Document No 7202-D0001-12
14
INSTALLATION
– continued
5.
Connecting Truck Electrics to the Diesel Engine Driven Compressor Unit
Electrical connection of SMAC to the truck is very simple. The entire control system is mounted in the
SMAC.
6.
Connection of the Diesel Engine Driven Compressor Unit to the fuel tank.
7.
Supply of After Cooler for SMAC is standard across the board.
It is important for most air tools, that the air supplied should be free of moisture. High content of
moisture in the air will considerably reduce the reliability and life of the air tool. In applications such as
painting with air guns, the finish can be greatly affected by moisture in the air.
Filters used in the standard filter regulator lubricator units have a limit to what they can handle. It is
suggested in areas of high humidity or in situations where the standard FRL is not able to cope with
the moisture an AFTERCOOLER is installed onto the compressor unit. A
An MEA water separator can be installed with electric solenoid operated drain valve part number
8.
Completing the Installation - Before Checking the System
Make sure that the following have been completed before operating the MEA Diesel Engine Driven
Compressor Unit
1.
Check the compressor oil level; make sure the compressor has been filled to the correct level
prior to shipping. Note that the oil is very clear, and it is difficult to see the level.
2.
Check the engine coolant level.
3.
Check the engine oil level.
4.
Check fuel level.
5.
Do a final inspection to make sure that all fasteners and connections are tight.
6.
Check that all hoses and wiring are secure and protected.
Summary of Contents for SMAC 35DG/BFM
