13
TROUBLESHOOTING
----------------------------------------------------------------------------------------------------------------------------- ----------
SYMPTON
CAUSE
SOLUTION
Unit does not operate
There is no power to the unit.
Plug in the unit and check the
power outlet.
The ON/OFF button has not
been pressed.
Press the ON/OFF button.
Unit does not dehumidify or
collects little water
Ambient temperature is lower
than +5°C.
Under this condition the
dehumidifier becomes
inefficient. It is recommended
to switch off the dehumidifier.
Ambient temperature exceeds
32°C.
Under this condition the
compressor is overloaded and
switches off automatically. It is
recommended to switch off the
dehumidifier.
The ambient air humidity is
lower than 35%rh.
Under this condition the
dehumidifier becomes
inefficient and little water will
be collected.
The air filter is dirty and
blocked.
The air filter must be cleaned.
If the air filter is beyond
cleaning, it must be replaced.
Below the relative humidity set
point.
This is normal and is not a
fault.
The compressor is not on
The dehumidifier has just
turned on.
Wait three minutes for the
compressor to start up.
The overload protector is
defective.
Please contact Meaco.
The fan will not turn on
The machine is in Standby
Mode.
Turn the machine on by using
the UP and DOWN arrows.
The fan is not running.
Please contact Meaco.
