6
CONTROL PANEL
----------------------------------------------------------------------------------------------------------------------------- ----------
The unit is equipped with an electronic control board:
POWER
The blue LED indicates when the unit is connected to the mains.
SETPOINT
The green LED indicates when the unit has reached the target humidity level e.g. 60%rh,
50%rh or 40%rh. If the unit is set to run in ‘Continuous Mode’, this LED will not show as
there is no target humidity level.
WATER TANK FULL
The yellow LED indicates when the water tank is full. When the water tank is full the unit
will switch off. Once the water tank has been emptied and placed securely back in the unit,
it will start to run again as per its previous settings.
ALARM LIGHT
The red LED indicates when there is a fault with the machine. If this light shows, please
contact Meaco.
LED BAR
The LED bar will light up red to indicate which mode the dehumidifier has been set to. For
example, if the LED bar is showing one red lin
e the unit is currently in ‘Standby Mode’, if
the LED bar is showing two red lines the unit is currently in ‘Continuous Mode’, if the LED
bar is showing three red lines the unit is set to reach a target humidity level of 40%rh and
so on.
