3 [EN]
the heater on. Do not allow oil, grease, or other contaminants to be drawn into the heater. Do not clean the heater
with organic solvents.
14.
Never unplug the power cord without pressing the "ON/OFF" button first, as this could damage the unit. Never
unplug the heater before the fan has stopped blowing. Always unplug the unit when not in use or moving location.
To disconnect from the power supply, grip the plug and pull from the power socket. Never pull by the cord.
15.
Keep Electrical Components Dry: Never allow water inside the heater's electrical components. If these areas become
wet for any reason, thoroughly dry them before using the heater. If in doubt do not use the heater and consult a
qualified electrician or a Meaco approved engineer.
16.
The operator must make the operating instruction available for the user and make sure that the user does understand
the manual.
17.
To repair the unit, take it to a qualified service engineer. Repairs carried out by unqualified people may cause damage
to the unit or injury to persons or property and void the warranty.
ATTENTION: The heater is fitted with a
thermal cut out
and a
tip-over
switch
so if the heater starts to overheat or if it falls over then it will automatically turn
off.
UK PLUG WIRING
Wiring Instructions: Should it be necessary to change the plug please note the wires in the mains
lead are coloured in accordance with the following code:
BLUE - NEUTRAL
BROWN
– LIVE
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
1. The
BLUE
wire is the
NEUTRAL
and must be connected to the terminal that is marked with the letter
N
or
coloured
BLACK
.
2. The
BROWN
wire is the
LIVE
and must be connected to the terminal that is marked with the letter
L
or coloured
RED.
3. Always ensure that the cord grip is positioned and fastened correctly.
If a
13A (BS 1363)
fused plug is used it must be fitted with a
13A (BS 1362)
fuse. If in doubt consult a qualified
electrician.
Wiring for a 13 Amp Plug (BS 1363)
1. GENERAL ADVICE
Before
putting your heater into operation for the first time, the instruction manual should be studied carefully.
