5 [EN]
2. CONTROL PANEL
MeacoHeat Motion Eye 1.8kW
MeacoHeat MotionMove Eye 2.0kW
ON/OFF
- press the button once to turn the heater on or off. The heater will start in high output and continuous
no sensor mode.
Output
– selects either low or high heat. On the MeacoHeat MotionMove Eye 2.0kW it can also be used to
switch to fan only mode with no heat output.
Fan Only
– on the MeacoHeat Motion Eye 1.8kW this selects fan only mode with no heat output.
OSC
– on the MeacoHeat MotionMove Eye 2.0kW this starts or stops the heater from turning left and right through
60°.
OFF Timer
- on the MeacoHeat Motion Eye 1.8kW this allows you to have the heater automatically turn off after
a maximum of 7 hours of operation. This is not a daily run timer and the unit will not turn back on until you next
press the ON/OFF button.
STAT
- on the MeacoHeat MotionMove Eye 2.0kW this controls the temperature that the heater works to and
turns the heater on and off at this point automatically. You can select from either a low, medium or high heat
depending on how you like your room to feel.
Motion Detection
– the heater has a motion SENSOR at the top centre of the heater. When movement is
detected 1 meter in front of the heater the heater will turn on, when no motion has been detected for 1 minute
the heater will turn off until movement is detected again. If you select Sensor Off then all movement is ignored.
