6 [EN]
3. HEATER COOLDOWN
The heater will run its fan after you press the off button to cool itself down for approximately one minute.
After four hours of use the heater will turn itself off.
In Motion mode if the heater has not detected anyone present for 12 hours it will turn itself off.
4. OUTPUT
Model
Low
High
MeacoHeat Motion Eye 1.8kW
900 watts
1800 watts
MeacoHeat MotionMove Eye 2.0kW
1000 watts
2000 watts
5. SAFETY
This unit has a safety system, which automatically switches the appliance off, when it is overheating. If this happens
unplug the heater and allow cooling down for 20 minutes. Inspect and remove any objects on or adjacent to your heater. If
the defect occurs again do not attempt to repair the unit yourself. Unplug the heater from the power socket and take it to
an authorised service engineer for repair.
6. MAINTENANCE
Always turn off the power and disconnect the main cable before performing maintenance procedures. All service procedures
below are to
be executed with the unit unplugged
. Perform before each use or as needed.
Inspect the electrical cord for damage at regular intervals.
The working performance of the heater will be greatly reduced if the filter is blocked with dust. Check the filter at
least weekly. Clean the filter if it gets clogged.
1. Remove the filter
2. Vacuum any debris from the filter.
3. Re-install the filter into the heater.
7. STORAGE
Follow the guidelines below when storing the unit:
1.
Unplug the heater.
2.
Prior to storing the unit, clean the filter.
3.
Protect from dust and strong sunlight during storage, ideally use the original packaging.
