Couple Things You Might Have Done
That You Don’t Want To Do Again
•
You shortened the length of the tripod legs so you could see through the eye piece when
the telescope was completely horizontal. Then when the scope “slewed” around
(that is
fancy astronomer telescope talk to say the scope was moving side to side and up/down)
the eye piece was so low you had to stoop down in order to look through it. That is part
of the figuring out how to set up your own scope to fit you.
•
Hopefully you didn’t rest anything in the space between the mounting forks underneath
the telescope’s Optical Tube. That space is a
“Do Not Enter, No Trespassing Zone.”
You
might have noticed that when the scope as aimed at something nearly straight up in the
sky there is hardly any clearance between the scope and the bottom of the mount. There
is a clear potential to cause damage to the Slewing & Motor gears if things get jammed in
that space.
•
Did you put your hand on the scope or tripod when looking through the Eye Piece?
Notice all the vibration and that the subject matter of your viewing interest was bouncing
all over the place? You have to keep your hands off the equipment if you want a steady
image. The only time you want to be looking through the Eye Piece and touching the
scope is when you are adjusting the focus knob.