32
Remote Sensor Status
The wave icon above the current channel display shows the connection status of the corresponding
remote sensor:
Searching for the signals from the remote sensor
Corresponding remote sensor signal received successfully
No signals received for over 15 minutes
Icon Status
All Remote Sensor Signals Search Activation
The main unit can be manually activated to search for the signals from all remote sensors.
Press and hold the
DOWN
button to enable the search.
Rain Mode
The main unit records the total amount of the rainfall for the last hour, 24 hours, past day, past
week and the past month. The rainfall can be displayed in mm or inches.
There is a daily rainfall alert that can be programmed in the unit if the daily rainfall exceeds a
pre-programmed limit.
Accessing Rain Mode
Press main unit
UP
or
DOWN
until the
RAIN
icon
on the display starts flashing.
From the remote control: Press
.
Viewing Rain Statistics
In the Rain Mode, press either
SET
or
MEMORY
button to recall a rain statistics for the past
hour, past 24 hours, yesterday, past week or past month.
Tip:
For the rain rate, estimate the
Last Hour
rainfall value is understood as “inch/hr” or “mm/hr”.
Resetting the Rainfall Statistics Memory
In the Rain Mode, press and hold the
MEMORY
button to reset all rainfall statistics.
Setting Units for the Rain Display in inches or mm
In the Rain Mode, press and hold the
SET
button to toggle rainfall data units between mm and inches.
Enabling or Disabling the Daily Rainfall Alert
• In the Rain Mode press the
ALARM/CHART
button to display either the current rainfall
statistics or the daily rainfall alert with “
ALARM HI
” displayed.
• If the alert is disabled, the “
OFF
” will be displayed; otherwise the rainfall alert value will
be shown.
• When the rainfall alert is displayed, press the
UP
or
DOWN
to enable or disable it.
M
P
8
2
:
5
,
8
0
/
1
1
/
4
d
m
p
.
R
L
L
E
W
Y
E
N
O
H
)
G
N
E
(
1
M
I
W
3
2
9
E
T
32