SAFETY WARNING &
OPERATING PRECAUTIONS
the protection circuit activates, immediately discon-
nect the unit from the power source and allow it to
cool.
The compressor should take approximately 15 min-
utes to cool depending on ambient conditions. The
compressor protection circuit will automatically
reset when the temperature returns to a safe opera-
ting level.
NOTE: The thermal cut out will operate when
the motor reaches 105°C. The cylinder head will
operate at a higher temperature.
POWER CONNECTION:
SAFE HANDLING:
INFLATION:
STOPPING AND RESTARTING:
Use caution when connecting the unit to a power
source, as batteries can vent explosive gasses. Avoid
connections that could produce a spark. Consult
your vehicle’s manual or a qualified mechanic for
proper connection procedures.
Only move and hold the unit by the carry handle.
NEVER carry the air compressor by the hose or
power cords.
Only inflate the tyres to the manufacturer’s recom-
mended pressure (consult your vehicle’s manual or
check for a sticker inside the driver’s door frame or
glove box for vehicle manufacturer specifications).
DO NOT over inflate, as tyre failure or serious injury
could occur.
Turning the air compressor “ON” at high pressure can
overload the unit and result in blowing the fuse or
tripping the circuit breaker. If starting at a higher
inflation pressure, it is a good idea to turn the com-
pressor “ON” first before attaching the hose to the
NOTE: This air compressor is not fitted with a
pressure relief valve.
IMPORTANT: Please refer to the front of this
manual for full details on the maximum duty
cycle of the air compressor. Always allow your
compressor to cool before reuse.
WARNING
Mean Mother Air Compressors generate a
lot of heat so wear appropriate gloves to
protect your hands. DO NOT touch the unit
with bare hands after operation, use the
carry handle. Always allow the compressor
to cool completely before storage.
When using this air compressor, safety precautions should always be followed to reduce the risk of
personal injury and damage to the air compressor.
WORKING AREA CONDITIONS:
KEEP CHILDREN AWAY:
USE LEATHER GLOVES:
USE SAFETY GLASSES:
CORRECT USE OF COMPRESSED AIR:
Keep the working area well lit. DO NOT use this air
compressor in the presence of flammable gases or
liquids. Use the air compressor in dry conditions
only to avoid potential risk of electrical shock.
Keep children away from working area. NEVER let
children operate the air compressor.
When handling the air compressor, always use hand
protection to eliminate the possibility of burns.
Always wear approved safety glasses when working
with compressed air from your air compressor.
NEVER aim the air stream at anyone’s eyes or skin.
DO NOT use the air compressor for pumping, comp-
ressing or transferring any gas or liquid other than
tyre valve. If you are stopping the air compressor and
restarting during an inflation operation, then you
should remove the hose from the valve once you
have turned the air compressor “OFF”, then turn the
air compressor “ON” and reconnect to the tyre valve.
Page 05
Copyright © 2020 Haigh Australia Pty Ltd
