air. This air compressor is NOT designed for use as a
source of breathable air.
FREE AIR FLOW:
STEP 1:
Place the compressor on a dry level surface near the 12 Volt vehicle battery or power source.
STEP 2:
STAY ALERT:
This air compressor is designed for continuous air
flow. Never block the flow of the air with any device
or accessory. Damage to the air compressor or seri-
ous injury may occur and void the manufacturer’s
warranty.
Watch what you are doing. Use your common sense.
DO NOT use this air compressor when you are tired,
OPERATING YOUR
AIR COMPRESSOR
Note: If your tyres are within reach, it is possible to use the 0.5m adaptor hose with gauge independ-
ent of the 5 metre air hose using the same procedure as described above.
REPLACEMENT PARTS & ACCESSORIES:
WARNING LABELS AND STICKERS:
MODIFICATIONS:
SMALL ITEMS:
The air compressor is permanently lubricated during
manufacture. It is not necessary to lubricate this
unit.
DO NOT discard or remove any warning labels or
name plates on this air compressor. These contain
important safety information. If unreadable please
contact your nearest distributor to arrange replace-
ment stickers.
Never drill or modify this air compressor in any way.
This will void the manufacturer’s warranty.
Extra caution should be taken when inflating
small objects such as small tyres, bicycle tyres and
sporting balls as rapid inflation will occur. Pay close
attention to the pressure gauge and be prepared to
stop the air compressor when desired or manufac-
turer’s recommended pressure.
stressed or WHEN UNDER THE INFLUENCE OF
DRUGS, ALCOHOL OR MEDICATION.
Only genuine replacement parts should be used
when repairing or servicing the unit. Never use an
air compressor that shows any signs of damage.
Before operating the air compressor check that you are in a safe location away from busy roads and
traffic, inspect the compressor and accessories for any sign of damage. If there are signs of damage
do not use the air compressor and replace damaged parts.
1.
Slide the retaining ring back on the female air hose quick connector on the hose and hold.
Connect the 5 metre air hose to the air compressor using the quick connector, then attach the
0.5m adaptor hose with gauge. To use the quick connector, follow these steps:
2.
Connect the 5 metre air hose to the air compressor by firmly inserting the male quick connector
located on the air compressor unit into the female quick connector.
3.
Release the retaining ring to lock the connectors in place.
Page 06
Copyright © 2020 Haigh Australia Pty Ltd
