USB-ERB08 User's Guide
Installing the USB-ERB08
8
Installing the hardware
To connect the USB-ERB08 to your system, complete the following steps.
1.
Turn your computer on.
2.
Connect the USB cable to the USB connector labeled
USB IN
on the USB-ERB08.
3.
Connect the other end of the USB cable to a USB port on your computer or to an external USB hub that is
connected to your computer.
The
USB
LED turns on. Refer to Figure 5 on page 9 for the location of the
USB
LED.
Windows finds and installs the device driver automatically and notifies you that the device is ready to use.
If the USB LED turns off
If communication is lost between the device and the computer, the
USB
LED turns off. To restore
communication, disconnect the USB cable from the computer and then reconnect it. This should restore
communication, and the
USB
LED should turn on.
If your system does not detect the USB-ERB08
If a
USB device not recognized
message displays when you connect the USB-ERB08, complete the following
steps:
1.
Unplug the USB cable from the USB-ERB08.
2.
Unplug the external power cord from the
POWER IN
connector on the enclosure.
3.
Plug the external power cord back into the
POWER IN
connector.
4.
Plug the USB cable back into the USB-ERB08.
Your system should now properly detect the USB-ERB08.
Contact technical support if your system still does not detect the USB-ERB08.
Caution!
Do not disconnect any device from the USB bus while the computer is communicating with the
USB-ERB08, or you may lose data and/or your ability to communicate with the USB-ERB08.
