EH
‐
SS
.
3
.
Check Weighing (Data Compare) Mode
The check weighing or data compare function allows the user to input a pre-set range, and the display will indicate
whether the weighed value is within that range, or indicate if it is too high or too low.
1.
From normal weighing mode, press the SET/0~9 key for 3 seconds to enter Setup mode.
2.
Press and release the SET/0~9 key to cycle through the parameters until “rAngE” is shown. Press the TARE
key to confirm.
3.
Press the SET/0~9 key to until “on” is shown. Press the TARE key to confirm.
4.
The previously used lower limit value will be displayed with the first digit flashing and the Under light flashing.
Enter the lower limit of the checkweighing range using the SET/0~9 key to increase the flashing digit and the
TARE key to accept a digit and move to the next position.
Note: The decimal does not appear on the display when entering limit values, but the value should be entered
as if it did appear. For example: A lower limit of 2.55 pounds should be entered as 02550 on the display.
5.
The previously used upper limit value will be displayed with the first digit flashing and the Over light flashing.
Enter the upper limit of the checkweighing range using the SET/0~9 key to increase the flashing digit and
the TARE key to accept a digit and move to the next position. After the last digit has been entered, the scale
will return to weighing mode and checkweighing may begin.
Note: The upper limit must be larger than lower limit. If it is not, “oFF” will be displayed and the scale will
return to the normal weighing mode and checkweighing will be deactivated.
6.
Place objects on the scale platform. The weight will be shown on the display. If the weight is within the
specified range, the Accept light will be lit and an audible tone will sound. If the value is outside the specified
range, the Over or Under light will be lit with no audible sound.
Note: The audible tone parameter can be changed from its default within User Setup mode.
Note: If the weight has not stabilized, no lights will be lit.
7.
To turn off the checkweighing function, enter Setup mode following steps 1-3 above and change the setting
to “oFF”.
Counting Mode
The counting function calculates and displays the piece quantity of the load that is being weighed.
1.
From normal weighing mode, press the SET/0~9 key for 3 seconds to enter Setup mode.
2.
Press and release the SET/0~9 key to cycle through the parameters until “UnItS” is shown. Press the TARE
key to confirm.
3.
Press the SET/0~9 key to until “PcS” is displayed. Press the TARE key to confirm. The pcs light will be lit.
4.
If a piece-weight has been entered previously, it will be shown. If no piece weight exists in the scale’s memory,
the pcs light will flash. To use the existing piece-weight, skip to step 7 below to begin counting items. To enter
a new piece-weight, follow steps 5 and 6.
5.
While in counting mode, press and hold the ON/ZERO key until the word “COUnt” is displayed briefly. Then the
pcs light will flash and “0” will be displayed.
6.
Place a known quantity of items on the scale platform and press the TARE key. “00000” will be displayed with
