EH
‐
SS
.
5
.
User Parameter Setup Mode
1.
From normal weighing mode, press the SET/0~9 key for 3 seconds to enter Setup mode.
2.
Press and release the SET/0~9 key to cycle through the parameter modes listed below.
3.
To enter a parameter mode, press the TARE key.
4.
Within a parameter mode, press the SET/0~9 key to cycle through the options for that setting.
5.
Press the TARE key to select the setting and to exit setup mode.
Parameter
Default
Setting
rAngE oFF
Activate checkweighing function:
on = Activate the checkweighing function and enter range limits
oFF = Deactivate the checkweighing function
UnItS Lb.Lb
Select the unit of measure:
H9 = Kg
9 = g
Lb.Lb = Pounds
Lb.oZ = Pounds/ounces
PcS = Counting mode (piece count will be displayed; weight will not)
Note: Calibration must be done in Kg or g
A- oFF
y
Auto off mode:
n = No auto power off
y = Auto off after 10 minutes of no operation or weight change
FILtX FILt3
Display response speed:
FILt1 = one step to display
FILt2 = 3-4 steps to display
FILt3 = 6-8 steps to display
FILt4 = display is fast
ZEro 1d
Set auto-zero range:
0.5d
1d
1.5d
2d
2.5d
3d
3.5d
4d
4.5d
5d
Where “d” is the readability. See Specifications.
bUZZEr on
on = Audible tone is on
oFF = Audible tone is off
D
See
specifications
Change divisions: (This setting should not be changed)
If this mode is entered accidentally, refer to the specification chart for the
divisions for your scale. Press the SET/0~9 key to choose the default
division setting and press the TARE key to confirm and exit.
d-dP y
Dual display mode:
n = front display only
y = front and rear display
