EH
‐
SS
.
6
.
Battery and Charging
There are three battery indicators on the display.
High = Battery voltage is greater than 6.3V
Mid = Battery voltage is between 6V and 6.3V
Low = Battery voltage is lower than 6V
Note: If the battery voltage falls below 5.6V, the scale will automatically power off.
Power is supplied by an internal rechargeable 6V Ni-MH battery (3800 mAh). When “-bAtLo-” is displayed, the
battery must be recharged. Plug in the AC power cord to recharge the battery. Full charging time is approximately
10-12 hours. The scale may continue to be used on AC power during charging.
Battery life and recharge time will vary with use. Over time, the operating time per each full charge will degrade. If
the operating time is no longer acceptable, the battery must be replaced. When storing the scale for extended
periods, the battery must be charged every 90 days to avoid premature performance degradation.
Character Prompt Definitions
dc x.xx
Battery voltage is x.xx volts
------
Scale capacity has been exceeded. Reduce the weight on the platform.
-AdC-
Analog/Digital converter overflow. Remove weight, zero the scale, and try again.
bATLo
Battery is low and should be charged soon
c _End
Battery recharging is complete
Err-0
Scale has been overloaded. Remove weight, zero the scale, and try again. If error code
persists, loadcell has been damaged. Loadcells are not replaceable by the user. Contact the
manufacturer at www.measuretek.net.
