EHC
‐
WF
.
2
.
2.
Unpacking and Setup
Remove the scale from the box and place it on a firm, level surface. Avoid locations with rapid temperature changes,
excessive dust, moisture, air currents, vibrations, electromagnetic fields, heat or direct sunlight.
Adjust the leveling feet until the bubble is centered in the circle of the level indicator
(located on the front panel).
NOTE: Ensure that the scale is level each time its location is changed.
The internal rechargeable battery should be fully charged for up to 12 hours before using the scale for the first time.
Connect the supplied AC adapter to the power input receptacle underneath the scale. Plug the AC adapter into a
properly grounded power outlet. The battery will begin charging.
If the scale will be stored or transported in the future, save the packaging material to ensure the best possible
protection for the scale.
Contents
Scale
12Vdc/500mA adapter
Manual
3.
OVERVIEW OF CONTROLS AND FUNCTIONS
3.1 Front Display
- Scale is zeroed, gross weight is 0, tare is 0.
- Scale is stable.
NET - Display reading is net weight; tare is not 0.
GROSS - Display reading is gross weight;
- Display data is accumulated total times, weight, pieces.
TARE - Display reading is net weight; tare is not 0.
lb - Measure unit is lb.
oz - Measure unit is oz.
kg - Measure unit is kg or g.
% - Measure unit is % (in percentage weighing mode).
Pcs - Measure unit is pieces (in counting mode).
HI - Check-weighing is enabled. Current data is above the specified upper limit.
OK - Check-weighing is enabled. Current data is between the specified upper and lower limits.
LO - Check-weighing is enabled. Current data is below the specified lower limits.
- Battery level.
