Measuretek PS-102-200, Operation Manual

PS

‐

102

www.measuretek.net

.

4

.

User Parameter Setup Mode 

1.

From normal weighing mode, press UNIT and ZERO/ON/OFF until “USer” is displayed. 

2.

Within user parameter setup mode: 



Press PRINT/HOLD to shift the flashing data entry position from right to left   



Press UNIT to increase the digit in the flashing data entry position by 1 



Press TARE to confirm and save the set data and enter next setting   



Press ZERO/ON/OFF key to exit this mode 

Parameter 

Default 

Setting 

U1 05 

Auto-off time:   



0 = No auto-off function     



01-15 = Scale will auto power off after 1-15 minutes with no activity 

U2 2 

Backlight on-off mode option: 



0 = Backlight is always off     



1 = Backlight is always on     



2 = Backlight is auto-off after 10 seconds with no activity   

U3 2 

PRINT/HOLD key function set: 



0 = Hold only     



1 = Print only     



2 = Hold and Print 

U4 0 

Hold function mode:



0 = No hold function     



1 = Holds the largest weight reading 



2-50 = Displays the stable weight within 3 seconds. 
Note: When weight exceeds 10d and the variation is within ±2d

～

±50d, the stable weight 

is displayed until less than 10d is detected on the platform. 
1d = 1 division = 1 unit of readability as noted in Specifications 

U5 1 

Serial communication output format: 



0= Communication is disabled 



1 = Outputs stable weight, unit, and status when PRINT/HOLD is pressed, but does not 
receive data 



2 = Output gross, tare, net weight, unit, and status when PRINT/HOLD is pressed, but does 
not receive data 



3 = Continuously outputs displayed weight, unit, and status, but does not receive data 



4 = Continuously outputs gross, tare, net weight, unit, and status, but does not receive data



5 = Outputs weight, unit, and status one time after scale is becomes stable   



6 = Outputs gross, tare, net weight, unit, and status one time after scale becomes stable 



7 = Two way communication mode 

U6 3 

Baud rate for Serial communication: 



0 = 1200 



3 = 9600 



1 = 2400 



4 = 19200 



2 = 4800 

U7 0 

Serial communication byte format:   



0 = 8N1 – 8 data bits, no parity, 1 stop bit 



1 = 7O1 – 7 data bits, 1 bit odd parity, 1 stop bit 



2 = 7E1 – 7 data bits, 1 bit even parity, 1 stop bit