Page 15
1330SE - Servce & Parts Manual
November 2021
Secton 10 - Mantenance
Pre-Start Inspection Checklist
Items on this checklist should be inspected before each work shift. Refer to the Operator’s Manual.
The operator must conduct a Pre-Start Inspection of the machine before each work shift.
DO NOT use a damaged or malfunctioning machine.
Initial
Description
Be sure that the operator’s manual are complete, legible and in the storage container
located in the platform.
Be sure that all decals are legible and in place. See Decals section.
Check for hydraulic oil leaks.
Check for battery fluid leaks.
Check the following components or areas for damage, improperly installed or missing parts and
unauthorized modifications:
Electrical components, wiring and electrical cables
Battery connections
Hydraulic hoses, fittings, cylinders and manifolds
Battery pack and connections
Drive motors
Tires and wheels
Ground strap
Limit switches, alarm and beacon
Nuts, bolts and other fasteners
Platform entry gate
Safety arm
Platform extension
Scissor pins and retaining fasteners
Platform control joystick
Check entire machine for:
Cracks in welds or structural components
Dents or damage to machine
Be sure that all structural and other critical components are present and all associated
fasteners and pins are in place and properly tightened
Be sure that the Component Tray is closed and latched and the batteries are properly
connected.
NEVER perform work or inspection on the machine with the platform
elevated without first blocking the scissor assembly with the
Maintenance Lock. See page 8 for instructions.
