Page 108
Speed Level Seres - Servce & Parts Manual
January 2019
Secton 8 - Troubleshootng - 3084RT Models
Function Active Messages
The following HELP messages indicate that there is no problem with the GP400 but that a function is
active – the vehicle should be moving as requested by the operator.
DRIVING! _____________________________________________ (no flash code)
LIFTING! ______________________________________________ (no flash code)
LOWERING! ___________________________________________ (no flash code)
STEERING! ___________________________________________ (no flash code)
EXTENDING OUTRIGGERS! ______________________________ (no flash code)
RETRACTING OUTRIGGERS! ____________________________ (no flash code)
Calibration Messages
The following are “calibration” HELP messages – until the machine is properly calibrated for height
and/or pressure (as required), many functions will not be available.
NOT CALIBRATED ______________________________________ Flash Code: 1/1
FUNCTIONS LOCKED - NOT CALIBRATED __________________ Flash Code: 1/1
The height and/or pressure sensors have not been calibrated and are required because of the
setup of the GP400.
Calibration procedures are accessible from the SETUPS/HEIGHT SETUPS and SETUPS/LOAD
SETUPS menus.
FAULT: CUSTOMER _____________________________________ Flash Code: 1/1
The system must be configured to the customer requirements – with the EZ-Cal in SETUPS/
CHANGE DEFAULTS menu, scroll to the correct machine from this menu, the press Right Arrow
to select the appropriate model.
Note:
Selecting the incorrect customer or model will cause the machine to operate incorrectly or go
into fault mode.
•
•
•
