Page 19
3084ES Speed Level
TM
- Operator’s Manual
August 2020
Secton 6 - Functon Tests and Operatng Instructons
Leveling Procedure
Leveling of the machine can only be performed when the platform height is below the Stowed Height
Limit Switch setting of approximately 10 feet (3 m).
When operating on a sloped surface, the platform can be brought to level using the AUTO LEVEL
switch or the MANUAL LEVEL switches.
Do Not drive elevated across uneven terrain (see Tip-over Hazards on
page 8)�����
ART_3238
Note:
The platform will not elevate unless it is level.
Auto Level
Move the toggle switch DOWN to start leveling.
Hold the toggle switch DOWN until leveling operation is complete.
When the platform reaches the level position, the TILT light will turn
OFF and the machine will stop correcting.
•
•
•
ART_3239
Manual Level: Front to Rear
Tilt to Front:
Move and hold the toggle switch to the LEFT to tilt the
platform to the desired position.
Tilt to Rear:
Move and hold the toggle switch to the RIGHT to tilt the
platform to the desired position.
•
•
ART_3240
Manual Level: Side to Side
Tilt to Left:
Move and hold the toggle switch to the LEFT to tilt the
platform to the desired position.
Tilt to Right:
Move and hold the toggle switch to the RIGHT to tilt the
platform to the desired position.
•
•
Shutdown Procedure
ART_2356
When finished with the machine, place the platform in the stowed
position.
Park the machine on a level surface.
Turn the platform controls selector switch to the OFF position.
Carefully exit the platform using a constant three (3) point dismount/grip.
Turn the key switch to the OFF position and remove the key to prevent
unauthorized use.
Turn the battery disconnect switch to the OFF position.
Note:
Leaving the battery disconnect switch in the ON position for an extended
time will drain the battery. Always put the switch in OFF position when
leaving the machine at the end of the work day.
Put a padlock on the battery disconnect switch to prevent unauthorized
operation.
•
•
•
•
•
•
•
