Page 14
69 Seres - Operator’s Manual
February 2019
Secton 5 - Pre-Operaton & Workplace Inspecton
Pre-Operation Inspection Report
Be sure that the operator’s, safety and responsibilities manuals are complete, legible and in the storage
container located in the platform.
Be sure that all decals are legible and in place. See Decals section.
Check for engine oil leaks and proper oil level. Add oil if needed. See Maintenance section.
Check for hydraulic oil leaks and proper oil level. Add oil if needed. See Maintenance section.
Check for engine coolant leaks and proper level of coolant. Add coolant if needed. See Maintenance section.
Check for battery fluid leaks and proper fluid level. Add distilled water if needed. See Maintenance section.
Check the following components or areas for damage, improperly installed or missing parts and
unauthorized modifications:
Electrical components, wiring and electrical cables
Hydraulic hoses, fittings, cylinders and manifolds
Fuel and hydraulic tanks
Drive motors
Wear pads
Tires and wheels
Engine and related components
Limit switches, alarms and horn
Nuts, bolts and other fasteners
Platform overload components
Platform entry gate
Brake release components
Beacon (if equipped)
Safety arm
Platform extension(s)
Scissor pins and retaining fasteners
Platform control handle
Generator (if equipped)
Outrigger housings and footpads (if equipped)
Check entire machine for:
Cracks in welds or structural components
Dents or damage to machine
Excessive rust, corrosion or oxidation
Be sure that all structural and other critical components are present and all associated fasteners and pins are
in place and properly tightened
Be sure guardrails are installed and bolts are fastened.
Note:
If the platform must be raised to inspect the machine, make sure the safety arm is in place. See
Operating Instructions section.
