Page 93
45-J Desel - Servce & Parts Manual
January 2022
Secton 18 - Mechancal Components
Lubrication Points
Boom Wear Pads
With the boom in the stowed position, raise the jib and extend the boom completely. Spread a thin,
even coat of lithium-based grease on the areas where the wear pads rub -- top, bottom and sides of
the internal sections of the boom.
Swing Bearing & Gear
Ball Bearing - apply approximately 15g
(approximately 10 pumps on a standard
grease gun) then rotate swing bearing 45°.
Repeat this thru 180° of swing or 4 times.
Apply 325g (approximately 80 pumps on a
standard grease gun) to the worm gear. Do
this thru 180° of motion while swim bearing is
turning.
While swing leveling is turning, apply 18g
(approximately 4 pumps from a standard
grease gun.)
1.
2.
3.
Worm Gear
Art_5517
Roller Bearing Lubrication Point
Roller Bearing Lubrication Point
2X Ball Bearings Lubrication Points
Cabinet Latches And Hinges
Apply spray lubricant to latches and hinges. Wipe off excess lubricant.
Engine
Apply spray lubricant to throttle solenoid linkage pivot points. See page 81.
