Page 47
45-J Desel - Servce & Parts Manual
January 2022
Secton 13 - Sensors, Relays & Alarms
Alarms
Tilt Alarm
The Tilt Alarm is a dual-tone alarm that sounds at the Base Controls Box when the angle of the
platform is outside of acceptable levels of operation (as measured by the GP400 inside the Lower
Control Box).
To Correct:
Manually lower the platform using the Level toggle switch and enable or retract and
lower the boom until the platform is in the stowed position. Move the machine to a firm
level surface before repositioning the platform.
Overload Alarm
On machines equipped with the optional Overload Sensing System, the Overload Alarm is a dual-tone
alarm that sounds at the Base Controls Box when the control system senses an overload situation.
The Overload Alarm is installed on machines equipped with the optional Overload Sensing System.
To Correct:
Remove weight from the platform before operation can continue.
Alert Sounds
The Platform Descent Alarm is optional but may be required in certain areas of operation. This
alarm sounds from the Base Controls Box.
The All-Motion Alarm is optional and sounds at the Base Controls Box.
The Horn is activated by button from the Upper Controls Station and sounds from the Base
Controls Box.
•
•
•
