Page 80
65-J Desel - Servce & Parts Manual
February 2021
Secton 18 - Mechancal Components
Assembly
The boom must be properly shimmed to function correctly. Each boom section must be shimmed to
a clearance no greater than 0.030” (0.762mm) at its tightest point of travel. It may be necessary to
run each boom section in and out several times to properly identify the tightest point of travel, and to
adjust the number of shims.
After the proper number of shims has been determined, tighten the mounting bolts for that set of
wear pads before moving on to the next step. Apply one (1) drop of Loctite® 242 or equivalent to
bolts securing wear pads and shims. See the Section 4 - Torque Specifications for proper torque
specifications.
Shims are not used on the larger square wearpads located on the top of the End section and bottom
of the Base Section.
Standard Shims
22224
Shim, .020” (0.5 mm)
11861977
Shim, .040” (1 mm)
11861981
Shim, .120” (3 mm)
11861982
Shim, .200” (5 mm)
11861983
Shim, .400” (10 mm)
Wear pads use M10-1.5 bolts in varying lengths,
depending on shim use. Use minimum bolt length
needed to fully engage threaded insert. Wear
pad bolts must be installed with M10 Nordlock
washers.
ART_4963
Wear Pad
Wear Pad
Threaded Insert
M10 Nordlock Washer
Bolt
Shim as needed to achieve
.030” total clearance in both
side-to-side and
top-to-bottom directions.
Use minimum bolt length
needed to fully engage
threaded insert.
Wear pads use M10-1.5 bolts
in varying lengths,
depending on shim use.
Bolts & Washers
50033
Bolt, M10 x 25
50034
Bolt, M10 x 30
50332
Bolt, M10 x 35
50035
Bolt, M10 x 40
50036
Bolt, M10 x 50
50021
Bolt, M10 x 55
50006
Washer, M10 Nordlock
