30750
14MBX
M1
61
14.2.7 Adjusting the Inching flex
1-
Place the machine on stabiliser support, with wheels
raised; forward movement with low speed engaged,
engine in maximum regime.
2-
Place full pressure on the Inching pedal until the wheels
stop, then gradually release the pedal until the wheels
start moving again.
3-
Measure the high pressure while the wheels are
rotating (1 fig. 1) using the manometer.
Note: The pressure should not rise sharply
when the wheels begin to rotate again.
4-
If the manometer reading indicates a sharp rise
between the transfer of position from brake/Inching,
loosen the screw (1 fig. 2).
17 flat spanner
5 flat hexagonal spanner
Manometer, 0-600 bars
Operation
High pressure
(bars)
Measurement
(ref. no.)
Adjustment
(ref. no.)
Inching and brake
No sharp rise
1 fig. 1
1 fig. 2
Fig. 2 Transfer movement pump
Fig. 1 Transfer movement engine
1
1
Summary of Contents for 14 MBX
