Cut to measure the tubular bars.
First fix the lateral supports, through which the bars are to be inserted, and install the telescopic arms, then weld the ends of the
tubular bars to the sliding plates of the telescopic arms.
English
!
It is recommended that Aproli 480 square shafts be
lubricated before being fitted with the tubular bars
It is recommended that the telescopic
arms be lubricated along the sliding
surface into the tubular section
Fasten the telescopic
arms to the fixing plates
Fix the lateral
supports
Weld the end of the tubular
bar to the sliding plate
of the telescopic arm
Pic. 10
Pic. 12
Pic. 13
Pic. 11
L
L
L
!
Lateral support to
take the tubular bar
!
The fastening pins are to be
tightened hard into the cavities
8
Oil-hydraulic operator for tilt-up doors with counterbalance
APROLI 480
GREASE
GREASE
GREASE
istr_aproli480_GB.ai 8 26/09/2018 15:59:30
